include/configs/M5275EVB.h

   1 /*
   2  * Configuation settings for the Motorola MC5275EVB board.
   3  *
   4  * By Arthur Shipkowski <art@videon-central.com>
   5  * Copyright (C) 2005 Videon Central, Inc.
   6  *
   7  * Based off of M5272C3 board code by Josef Baumgartner
   8  * <josef.baumgartner@telex.de>
   9  *
  10  * SPDX-License-Identifier:     GPL-2.0+
  11  */
  12
  13 /*
  14  * board/config.h - configuration options, board specific
  15  */
  16
  17 #ifndef _M5275EVB_H
  18 #define _M5275EVB_H
  19
  20 /*
  21  * High Level Configuration Options
  22  * (easy to change)
  23  */
  24 #define CONFIG_M5275EVB                 /* define board type */
  25
  26 #define CONFIG_MCFTMR
  27
  28 #define CONFIG_MCFUART
  29 #define CONFIG_SYS_UART_PORT            (0)
  30 #define CONFIG_BAUDRATE         115200
  31
  32 /* Configuration for environment
  33  * Environment is embedded in u-boot in the second sector of the flash
  34  */
  35 #ifndef CONFIG_MONITOR_IS_IN_RAM
  36 #define CONFIG_ENV_OFFSET               0x4000
  37 #define CONFIG_ENV_SECT_SIZE    0x2000
  38 #define CONFIG_ENV_IS_IN_FLASH  1
  39 #else
  40 #define CONFIG_ENV_ADDR         0xffe04000
  41 #define CONFIG_ENV_SECT_SIZE    0x2000
  42 #define CONFIG_ENV_IS_IN_FLASH  1
  43 #endif
  44
  45 #define LDS_BOARD_TEXT \
  46         . = DEFINED(env_offset) ? env_offset : .; \
  47         common/env_embedded.o (.text);
  48
  49 /*
  50  * BOOTP options
  51  */
  52 #define CONFIG_BOOTP_BOOTFILESIZE
  53 #define CONFIG_BOOTP_BOOTPATH
  54 #define CONFIG_BOOTP_GATEWAY
  55 #define CONFIG_BOOTP_HOSTNAME
  56
  57 /* Available command configuration */
  58
  59 #define CONFIG_MCFFEC
  60 #ifdef CONFIG_MCFFEC
  61 #define CONFIG_MII              1
  62 #define CONFIG_MII_INIT         1
  63 #define CONFIG_SYS_DISCOVER_PHY
  64 #define CONFIG_SYS_RX_ETH_BUFFER        8
  65 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  66 #define CONFIG_SYS_FEC0_PINMUX          0
  67 #define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE
  68 #define CONFIG_SYS_FEC1_PINMUX          0
  69 #define CONFIG_SYS_FEC1_MIIBASE CONFIG_SYS_FEC1_IOBASE
  70 #define MCFFEC_TOUT_LOOP        50000
  71 #define CONFIG_HAS_ETH1
  72 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
  73 #ifndef CONFIG_SYS_DISCOVER_PHY
  74 #define FECDUPLEX               FULL
  75 #define FECSPEED                _100BASET
  76 #else
  77 #ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  78 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  79 #endif
  80 #endif
  81 #endif
  82
  83 /* I2C */
  84 #define CONFIG_SYS_I2C
  85 #define CONFIG_SYS_I2C_FSL
  86 #define CONFIG_SYS_FSL_I2C_SPEED        80000
  87 #define CONFIG_SYS_FSL_I2C_SLAVE        0x7F
  88 #define CONFIG_SYS_FSL_I2C_OFFSET       0x00000300
  89 #define CONFIG_SYS_IMMR         CONFIG_SYS_MBAR
  90 #define CONFIG_SYS_I2C_PINMUX_REG       (gpio_reg->par_feci2c)
  91 #define CONFIG_SYS_I2C_PINMUX_CLR       (0xFFF0)
  92 #define CONFIG_SYS_I2C_PINMUX_SET       (0x000F)
  93
  94 #define CONFIG_SYS_LONGHELP             /* undef to save memory */
  95
  96 #if (CONFIG_CMD_KGDB)
  97 #       define CONFIG_SYS_CBSIZE        1024
  98 #else
  99 #       define CONFIG_SYS_CBSIZE        256
 100 #endif
 101 #define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
 102 #define CONFIG_SYS_MAXARGS              16
 103 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
 104
 105 #define CONFIG_SYS_LOAD_ADDR            0x800000
 106
 107 #define CONFIG_BOOTCOMMAND      "bootm ffe40000"
 108 #define CONFIG_SYS_MEMTEST_START        0x400
 109 #define CONFIG_SYS_MEMTEST_END          0x380000
 110
 111 #ifdef CONFIG_MCFFEC
 112 #       define CONFIG_NET_RETRY_COUNT   5
 113 #       define CONFIG_OVERWRITE_ETHADDR_ONCE
 114 #endif                          /* FEC_ENET */
 115
 116 #define CONFIG_EXTRA_ENV_SETTINGS               \
 117         "netdev=eth0\0"                         \
 118         "loadaddr=10000\0"                      \
 119         "uboot=u-boot.bin\0"                    \
 120         "load=tftp ${loadaddr} ${uboot}\0"      \
 121         "upd=run load; run prog\0"              \
 122         "prog=prot off ffe00000 ffe3ffff;"      \
 123         "era ffe00000 ffe3ffff;"                \
 124         "cp.b ${loadaddr} ffe00000 ${filesize};"\
 125         "save\0"                                \
 126         ""
 127
 128 #define CONFIG_SYS_CLK                  150000000
 129
 130 /*
 131  * Low Level Configuration Settings
 132  * (address mappings, register initial values, etc.)
 133  * You should know what you are doing if you make changes here.
 134  */
 135
 136 #define CONFIG_SYS_MBAR         0x40000000
 137
 138 /*-----------------------------------------------------------------------
 139  * Definitions for initial stack pointer and data area (in DPRAM)
 140  */
 141 #define CONFIG_SYS_INIT_RAM_ADDR        0x20000000
 142 #define CONFIG_SYS_INIT_RAM_SIZE        0x10000 /* Size of used area in internal SRAM */
 143 #define CONFIG_SYS_GBL_DATA_OFFSET      (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 144 #define CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
 145
 146 /*-----------------------------------------------------------------------
 147  * Start addresses for the final memory configuration
 148  * (Set up by the startup code)
 149  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
 150  */
 151 #define CONFIG_SYS_SDRAM_BASE           0x00000000
 152 #define CONFIG_SYS_SDRAM_SIZE           16      /* SDRAM size in MB */
 153 #define CONFIG_SYS_FLASH_BASE           CONFIG_SYS_CS0_BASE
 154
 155 #ifdef CONFIG_MONITOR_IS_IN_RAM
 156 #define CONFIG_SYS_MONITOR_BASE 0x20000
 157 #else
 158 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400)
 159 #endif
 160
 161 #define CONFIG_SYS_MONITOR_LEN          0x20000
 162 #define CONFIG_SYS_MALLOC_LEN           (256 << 10)
 163 #define CONFIG_SYS_BOOTPARAMS_LEN       64*1024
 164
 165 /*
 166  * For booting Linux, the board info and command line data
 167  * have to be in the first 8 MB of memory, since this is
 168  * the maximum mapped by the Linux kernel during initialization ??
 169  */
 170 #define CONFIG_SYS_BOOTMAPSZ            (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
 171 #define CONFIG_SYS_BOOTM_LEN            (CONFIG_SYS_SDRAM_SIZE << 20)
 172
 173 /*-----------------------------------------------------------------------
 174  * FLASH organization
 175  */
 176 #define CONFIG_SYS_MAX_FLASH_BANKS      1       /* max number of memory banks */
 177 #define CONFIG_SYS_MAX_FLASH_SECT       11      /* max number of sectors on one chip */
 178 #define CONFIG_SYS_FLASH_ERASE_TOUT     1000
 179
 180 #define CONFIG_SYS_FLASH_CFI            1
 181 #define CONFIG_FLASH_CFI_DRIVER 1
 182 #define CONFIG_SYS_FLASH_SIZE           0x200000
 183
 184 /*-----------------------------------------------------------------------
 185  * Cache Configuration
 186  */
 187 #define CONFIG_SYS_CACHELINE_SIZE       16
 188
 189 #define ICACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
 190                                          CONFIG_SYS_INIT_RAM_SIZE - 8)
 191 #define DCACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
 192                                          CONFIG_SYS_INIT_RAM_SIZE - 4)
 193 #define CONFIG_SYS_ICACHE_INV           (CF_CACR_CINV | CF_CACR_INVI)
 194 #define CONFIG_SYS_CACHE_ACR0           (CONFIG_SYS_SDRAM_BASE | \
 195                                          CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
 196                                          CF_ACR_EN | CF_ACR_SM_ALL)
 197 #define CONFIG_SYS_CACHE_ICACR          (CF_CACR_CENB | CF_CACR_CINV | \
 198                                          CF_CACR_DISD | CF_CACR_INVI | \
 199                                          CF_CACR_CEIB | CF_CACR_DCM | \
 200                                          CF_CACR_EUSP)
 201
 202 /*-----------------------------------------------------------------------
 203  * Memory bank definitions
 204  */
 205 #define CONFIG_SYS_CS0_BASE             0xffe00000
 206 #define CONFIG_SYS_CS0_CTRL             0x00001980
 207 #define CONFIG_SYS_CS0_MASK             0x001F0001
 208
 209 #define CONFIG_SYS_CS1_BASE             0x30000000
 210 #define CONFIG_SYS_CS1_CTRL             0x00001900
 211 #define CONFIG_SYS_CS1_MASK             0x00070001
 212
 213 /*-----------------------------------------------------------------------
 214  * Port configuration
 215  */
 216 #define CONFIG_SYS_FECI2C               0x0FA0
 217
 218 #endif  /* _M5275EVB_H */