include/configs/ap_sh4a_4a.h

   1 /*
   2  * Configuation settings for the Alpha Project AP-SH4A-4A board
   3  *
   4  * Copyright (C) 2012 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
   5  *
   6  * SPDX-License-Identifier:     GPL-2.0+
   7  */
   8
   9 #ifndef __AP_SH4A_4A_H
  10 #define __AP_SH4A_4A_H
  11
  12 #define CONFIG_CPU_SH7734       1
  13 #define CONFIG_AP_SH4A_4A       1
  14 #define CONFIG_400MHZ_MODE      1
  15 /* #define CONFIG_533MHZ_MODE   1 */
  16
  17 #define CONFIG_SYS_TEXT_BASE 0x8BFC0000
  18
  19 #define CONFIG_CMD_SDRAM
  20 #define CONFIG_CMD_ENV
  21
  22 #define CONFIG_BOOTARGS         "console=ttySC4,115200"
  23
  24 #define CONFIG_DISPLAY_BOARDINFO
  25 #undef  CONFIG_SHOW_BOOT_PROGRESS
  26
  27 /* Ether */
  28 #define CONFIG_SH_ETHER 1
  29 #define CONFIG_SH_ETHER_USE_PORT (0)
  30 #define CONFIG_SH_ETHER_PHY_ADDR (0x0)
  31 #define CONFIG_SH_ETHER_PHY_MODE (PHY_INTERFACE_MODE_GMII)
  32 #define CONFIG_SH_ETHER_SH7734_MII (0x02) /* GMII */
  33 #define CONFIG_PHYLIB
  34 #define CONFIG_PHY_MICREL 1
  35 #define CONFIG_BITBANGMII
  36 #define CONFIG_BITBANGMII_MULTI
  37
  38 /* undef to save memory */
  39 #define CONFIG_SYS_LONGHELP
  40 /* Monitor Command Prompt */
  41 /* Buffer size for input from the Console */
  42 #define CONFIG_SYS_CBSIZE               256
  43 /* Buffer size for Console output */
  44 #define CONFIG_SYS_PBSIZE               256
  45 /* max args accepted for monitor commands */
  46 #define CONFIG_SYS_MAXARGS              16
  47 /* Buffer size for Boot Arguments passed to kernel */
  48 #define CONFIG_SYS_BARGSIZE     512
  49 /* List of legal baudrate settings for this board */
  50 #define CONFIG_SYS_BAUDRATE_TABLE       { 115200 }
  51
  52 /* SCIF */
  53 #define CONFIG_SCIF_CONSOLE     1
  54 #define CONFIG_SCIF                     1
  55 #define CONFIG_CONS_SCIF4       1
  56
  57 /* Suppress display of console information at boot */
  58
  59 /* SDRAM */
  60 #define CONFIG_SYS_SDRAM_BASE   (0x88000000)
  61 #define CONFIG_SYS_SDRAM_SIZE   (64 * 1024 * 1024)
  62 #define CONFIG_SYS_LOAD_ADDR    (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024)
  63
  64 #define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE)
  65 #define CONFIG_SYS_MEMTEST_END   (CONFIG_SYS_MEMTEST_START + CONFIG_SYS_SDRAM_SIZE)
  66 /* Enable alternate, more extensive, memory test */
  67 #undef  CONFIG_SYS_ALT_MEMTEST
  68 /* Scratch address used by the alternate memory test */
  69 #undef  CONFIG_SYS_MEMTEST_SCRATCH
  70
  71 /* Enable temporary baudrate change while serial download */
  72 #undef  CONFIG_SYS_LOADS_BAUD_CHANGE
  73
  74 /* FLASH */
  75 #define CONFIG_FLASH_CFI_DRIVER 1
  76 #define CONFIG_SYS_FLASH_CFI
  77 #undef  CONFIG_SYS_FLASH_QUIET_TEST
  78 #define CONFIG_SYS_FLASH_EMPTY_INFO
  79 #define CONFIG_SYS_FLASH_BASE   (0xA0000000)
  80 #define CONFIG_SYS_MAX_FLASH_SECT       512
  81
  82 /* if you use all NOR Flash , you change dip-switch. Please see Manual. */
  83 #define CONFIG_SYS_MAX_FLASH_BANKS      1
  84 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE }
  85
  86 /* Timeout for Flash erase operations (in ms) */
  87 #define CONFIG_SYS_FLASH_ERASE_TOUT     (3 * 1000)
  88 /* Timeout for Flash write operations (in ms) */
  89 #define CONFIG_SYS_FLASH_WRITE_TOUT     (3 * 1000)
  90 /* Timeout for Flash set sector lock bit operations (in ms) */
  91 #define CONFIG_SYS_FLASH_LOCK_TOUT      (3 * 1000)
  92 /* Timeout for Flash clear lock bit operations (in ms) */
  93 #define CONFIG_SYS_FLASH_UNLOCK_TOUT    (3 * 1000)
  94
  95 /*
  96  * Use hardware flash sectors protection instead
  97  * of U-Boot software protection
  98  */
  99 #undef  CONFIG_SYS_FLASH_PROTECTION
 100 #undef  CONFIG_SYS_DIRECT_FLASH_TFTP
 101
 102 /* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */
 103 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE)
 104 /* Monitor size */
 105 #define CONFIG_SYS_MONITOR_LEN  (256 * 1024)
 106 /* Size of DRAM reserved for malloc() use */
 107 #define CONFIG_SYS_MALLOC_LEN   (256 * 1024)
 108 #define CONFIG_SYS_BOOTMAPSZ    (8 * 1024 * 1024)
 109
 110 /* ENV setting */
 111 #define CONFIG_ENV_IS_IN_FLASH
 112 #define CONFIG_ENV_OVERWRITE    1
 113 #define CONFIG_ENV_SECT_SIZE    (128 * 1024)
 114 #define CONFIG_ENV_SIZE         (CONFIG_ENV_SECT_SIZE)
 115 #define CONFIG_ENV_ADDR         (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN)
 116 /* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
 117 #define CONFIG_ENV_OFFSET       (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE)
 118 #define CONFIG_ENV_SIZE_REDUND  (CONFIG_ENV_SECT_SIZE)
 119
 120 /* Board Clock */
 121 #if defined(CONFIG_400MHZ_MODE)
 122 #define CONFIG_SYS_CLK_FREQ 50000000
 123 #else
 124 #define CONFIG_SYS_CLK_FREQ 44444444
 125 #endif
 126 #define CONFIG_SH_TMU_CLK_FREQ CONFIG_SYS_CLK_FREQ
 127 #define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
 128 #define CONFIG_SYS_TMU_CLK_DIV      4
 129
 130 #endif  /* __AP_SH4A_4A_H */