include/configs/munices.h

   1 /*
   2  * (C) Copyright 2007
   3  * Heiko Schocher, DENX Software Engineering, hs@denx.de.
   4  *
   5  * SPDX-License-Identifier:     GPL-2.0+
   6  */
   7
   8 #ifndef __CONFIG_H
   9 #define __CONFIG_H
  10 /*
  11  * High Level Configuration Options
  12  * (easy to change)
  13  */
  14 #define CONFIG_MPC5200          1       /* This is an MPC5200 CPU */
  15 #define CONFIG_MPC5200_DDR      1       /* (with DDR-SDRAM) */
  16 #define CONFIG_MUNICES          1       /* ... on MUNICes board */
  17 #define CONFIG_SYS_GENERIC_BOARD
  18
  19 #ifndef CONFIG_SYS_TEXT_BASE
  20 #define CONFIG_SYS_TEXT_BASE    0xFFF00000
  21 #endif
  22
  23 #define CONFIG_SYS_MPC5XXX_CLKIN        33333333 /* ... running at 33.333333MHz */
  24 #define CONFIG_SYS_CACHELINE_SIZE       32      /* For MPC5xxx CPUs */
  25 #define CONFIG_HIGH_BATS        1       /* High BATs supported */
  26
  27 /*
  28  * Command line configuration.
  29  */
  30 #define CONFIG_CMD_ASKENV
  31 #define CONFIG_CMD_ELF
  32 #define CONFIG_CMD_IMMAP
  33 #define CONFIG_CMD_PING
  34 #define CONFIG_CMD_REGINFO
  35
  36 #if defined(CONFIG_CMD_KGDB)
  37 #  define CONFIG_SYS_CACHELINE_SHIFT    5       /* log base 2 of the above value */
  38 #endif
  39
  40 /*
  41  * Serial console configuration
  42  */
  43 #define CONFIG_PSC_CONSOLE      1       /* console is on PSC1 */
  44 #define CONFIG_BAUDRATE         115200  /* ... at 115200 bps */
  45 #define CONFIG_SYS_BAUDRATE_TABLE       { 9600, 19200, 38400, 57600, 115200, 230400 }
  46
  47 #define CONFIG_TIMESTAMP        1       /* Print image info with timestamp */
  48 #define CONFIG_BOOTDELAY        5   /* autoboot after 5 seconds */
  49 #undef  CONFIG_BOOTARGS
  50
  51 #define CONFIG_PREBOOT  "echo;" \
  52         "echo Type \"run net_nfs\" to load Kernel over TFTP and to mount root filesystem over NFS;" \
  53         "echo"
  54
  55 #define CONFIG_EXTRA_ENV_SETTINGS                                       \
  56         "netdev=eth0\0"                                                 \
  57         "nfsargs=setenv bootargs root=/dev/nfs rw "                     \
  58                 "nfsroot=$(serverip):$(rootpath)\0"                     \
  59         "ramargs=setenv bootargs root=/dev/ram rw\0"                    \
  60         "addip=setenv bootargs $(bootargs) "                            \
  61                 "ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask)"      \
  62                 ":$(hostname):$(netdev):off panic=5\0"                  \
  63         "flash_nfs=run nfsargs addip;"                                  \
  64                 "bootm $(kernel_addr)\0"                                \
  65         "flash_self=run ramargs addip;"                                 \
  66                 "bootm $(kernel_addr) $(ramdisk_addr)\0"                \
  67         "net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0"     \
  68         "rootpath=/opt/eldk/ppc_6xx\0"                                  \
  69         "bootfile=/tftpboot/munices/u-boot.bin\0"                       \
  70         "update=tftpboot 200000 ${bootfile};protect off fff00000 fff3ffff;" \
  71         "erase fff00000 fff3ffff; cp.b 200000 FFF00000 ${filesize}\0"   \
  72         ""
  73 #define CONFIG_BOOTCOMMAND      "run net_nfs"
  74
  75 /*
  76  * IPB Bus clocking configuration.
  77  */
  78 #define  CONFIG_SYS_IPBSPEED_133                /* define for 133MHz speed */
  79 #if defined(CONFIG_SYS_IPBSPEED_133)
  80 /*
  81  * PCI Bus clocking configuration
  82  *
  83  * Actually a PCI Clock of 66 MHz is only set (in cpu_init.c) if
  84  * CONFIG_SYS_IPBSPEED_133 is defined. This is because a PCI Clock of 66 MHz yet hasn't
  85  * been tested with a IPB Bus Clock of 66 MHz.
  86  */
  87 #define CONFIG_SYS_PCISPEED_66          /* define for 66MHz speed */
  88 #else
  89 #undef CONFIG_SYS_PCISPEED_66                   /* for 33MHz speed */
  90 #endif
  91
  92 /*
  93  * Memory map
  94  */
  95 #define CONFIG_SYS_MBAR         0xF0000000 /* MBAR hast to be switched by other bootloader or debugger config  */
  96
  97 #define CONFIG_SYS_DEFAULT_MBAR 0x80000000
  98 #define CONFIG_SYS_SDRAM_BASE           0x00000000
  99 /* Use SRAM until RAM will be available */
 100 #define CONFIG_SYS_INIT_RAM_ADDR        MPC5XXX_SRAM
 101 #define CONFIG_SYS_INIT_RAM_SIZE        MPC5XXX_SRAM_SIZE       /* Size of used area in DPRAM */
 102 #define CONFIG_SYS_GBL_DATA_OFFSET      (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 103 #define CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
 104
 105 #define CONFIG_SYS_MONITOR_BASE    CONFIG_SYS_TEXT_BASE
 106 #if (CONFIG_SYS_MONITOR_BASE < CONFIG_SYS_FLASH_BASE)
 107 #   define CONFIG_SYS_RAMBOOT           1
 108 #endif
 109
 110 #define CONFIG_SYS_MONITOR_LEN          (192 << 10)     /* Reserve 192 kB for Monitor   */
 111 #define CONFIG_SYS_MALLOC_LEN           (128 << 10)     /* Reserve 128 kB for malloc()  */
 112 #define CONFIG_SYS_BOOTMAPSZ            (8 << 20)       /* Initial Memory map for Linux */
 113
 114 /*
 115  * Flash configuration
 116  */
 117 #define CONFIG_SYS_FLASH_BASE           0xFF000000
 118 #define CONFIG_SYS_FLASH_CFI            1       /* Flash is CFI conformant */
 119 #define CONFIG_FLASH_CFI_DRIVER 1       /* Use the common driver */
 120 #define CONFIG_SYS_FLASH_BANKS_LIST     { CONFIG_SYS_FLASH_BASE }
 121 #define CONFIG_SYS_FLASH_EMPTY_INFO
 122 #define CONFIG_SYS_FLASH_SIZE           0x01000000 /* 16 MByte */
 123 #define CONFIG_SYS_MAX_FLASH_SECT       128     /* max num of sects on one chip */
 124 #define CONFIG_SYS_MAX_FLASH_BANKS      1        /* max num of flash banks (= chip selects) */
 125 #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE       /* not supported yet for AMD */
 126
 127 /*
 128  * Chip selects configuration
 129  */
 130 /* Boot Chipselect */
 131 #define CONFIG_SYS_BOOTCS_START CONFIG_SYS_FLASH_BASE
 132 #define CONFIG_SYS_BOOTCS_SIZE          CONFIG_SYS_FLASH_SIZE
 133 #define CONFIG_SYS_BOOTCS_CFG           0x00047800
 134
 135 /*
 136  * Environment settings
 137  */
 138 #define CONFIG_ENV_IS_IN_FLASH  1
 139 #define CONFIG_ENV_OFFSET               0x40000
 140 #define CONFIG_ENV_ADDR         (CONFIG_SYS_TEXT_BASE + CONFIG_ENV_OFFSET)
 141 #define CONFIG_ENV_SECT_SIZE    0x20000
 142 #define CONFIG_ENV_SIZE         0x4000
 143 #define CONFIG_ENV_OFFSET_REDUND   (CONFIG_ENV_OFFSET + CONFIG_ENV_SECT_SIZE)
 144 #define CONFIG_ENV_ADDR_REDUND  (CONFIG_SYS_TEXT_BASE + CONFIG_ENV_OFFSET_REDUND)
 145 #define CONFIG_ENV_SIZE_REDUND     (CONFIG_ENV_SIZE)
 146 #define CONFIG_ENV_OVERWRITE    1
 147
 148 /*
 149  * Ethernet configuration
 150  */
 151 #define CONFIG_MPC5xxx_FEC      1
 152 #define CONFIG_MPC5xxx_FEC_MII100
 153 #define CONFIG_PHY_ADDR         0x01
 154 #define CONFIG_MII              1
 155
 156 /*
 157  * GPIO configuration
 158  */
 159 #define CONFIG_SYS_GPS_PORT_CONFIG      0x00058044 /* PSC1=UART, PSC2=UART ; Ether=100MBit with MD
 160                                                 no PCI */
 161
 162 /*
 163  * Miscellaneous configurable options
 164  */
 165 #define CONFIG_SYS_LONGHELP                     /* undef to save memory     */
 166 #define CONFIG_SYS_CBSIZE               1024    /* Console I/O Buffer Size  */
 167 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)      /* Print Buffer Size */
 168 #define CONFIG_SYS_MAXARGS              16              /* max number of command args   */
 169 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE       /* Boot Argument Buffer Size    */
 170
 171 #define CONFIG_SYS_MEMTEST_START        0x00100000      /* memtest works on */
 172 #define CONFIG_SYS_MEMTEST_END          0x00f00000      /* 1 ... 15 MB in DRAM  */
 173
 174 #define CONFIG_SYS_LOAD_ADDR            0x200000        /* default load address */
 175
 176 #define CONFIG_DISPLAY_BOARDINFO 1
 177 #define CONFIG_CMDLINE_EDITING  1
 178
 179 /*
 180  * Various low-level settings
 181  */
 182 #define CONFIG_SYS_HID0_INIT            HID0_ICE | HID0_ICFI
 183 #define CONFIG_SYS_HID0_FINAL           HID0_ICE
 184
 185 #define CONFIG_SYS_CS_BURST             0x00000000
 186 #define CONFIG_SYS_CS_DEADCYCLE 0x33333333
 187 #define CONFIG_SYS_RESET_ADDRESS        0xff000000
 188
 189 /* pass open firmware flat tree */
 190 #define CONFIG_OF_LIBFDT        1
 191 #define CONFIG_OF_BOARD_SETUP   1
 192
 193 #define OF_CPU                  "PowerPC,5200@0"
 194 #define OF_TBCLK                (bd->bi_busfreq / 4)
 195 #define OF_SOC                  "soc5200@f0000000"
 196 #define OF_STDOUT_PATH          "/soc5200@f0000000/serial@2000"
 197
 198 #endif /* __CONFIG_H */