]> git.ipfire.org Git - people/ms/u-boot.git/blob - include/configs/omap3_pandora.h
Move defaults from config_cmd_default.h to Kconfig
[people/ms/u-boot.git] / include / configs / omap3_pandora.h
1 /*
2 * (C) Copyright 2008-2010
3 * GraÅžvydas Ignotas <notasas@gmail.com>
4 *
5 * Configuration settings for the OMAP3 Pandora.
6 *
7 * SPDX-License-Identifier: GPL-2.0+
8 */
9
10 #ifndef __CONFIG_H
11 #define __CONFIG_H
12
13 #define CONFIG_NR_DRAM_BANKS 2 /* CS1 may or may not be populated */
14 #define CONFIG_NAND
15
16 /* override base for compatibility with MLO the device ships with */
17 #define CONFIG_SYS_TEXT_BASE 0x80008000
18
19 #include <configs/ti_omap3_common.h>
20
21 /*
22 * Display CPU and Board information
23 */
24 #define CONFIG_DISPLAY_CPUINFO 1
25 #define CONFIG_DISPLAY_BOARDINFO 1
26
27 #define CONFIG_MISC_INIT_R
28 #define CONFIG_REVISION_TAG 1
29
30 #define CONFIG_ENV_SIZE (128 << 10) /* 128 KiB */
31
32 #define CONFIG_SYS_CONSOLE_IS_IN_ENV 1
33 #define CONFIG_SYS_DEVICE_NULLDEV 1
34
35 /*
36 * Hardware drivers
37 */
38
39 /* I2C Support */
40 #define CONFIG_SYS_I2C_OMAP34XX
41
42 /* TWL4030 LED */
43 #define CONFIG_TWL4030_LED
44
45 /* Initialize GPIOs by default */
46 #define CONFIG_OMAP3_GPIO_4 /* GPIO96..127 is in GPIO Bank 4 */
47 #define CONFIG_OMAP3_GPIO_6 /* GPIO160..191 is in GPIO Bank 6 */
48
49 /*
50 * NS16550 Configuration
51 */
52 #undef CONFIG_OMAP_SERIAL
53 #define CONFIG_SYS_NS16550_SERIAL
54 #define CONFIG_SYS_NS16550_REG_SIZE (-4)
55 #define CONFIG_SYS_NS16550_CLK V_NS16550_CLK
56 #define CONFIG_SYS_NS16550_COM3 OMAP34XX_UART3
57 #define CONFIG_SERIAL3 3
58
59 /* commands to include */
60 #define CONFIG_CMD_CACHE /* Cache control */
61
62 /*
63 * Board NAND Info.
64 */
65 #define CONFIG_SYS_NAND_ADDR NAND_BASE /* physical address */
66 /* to access nand */
67 #define CONFIG_SYS_NAND_BUSWIDTH_16BIT 16
68 #define CONFIG_NAND_OMAP_ECCSCHEME OMAP_ECC_HAM1_CODE_SW
69 #define CONFIG_SYS_NAND_PAGE_SIZE 2048
70 #define CONFIG_SYS_NAND_OOBSIZE 64
71
72 #ifdef CONFIG_NAND
73 #define CONFIG_CMD_UBI /* UBI-formated MTD partition support */
74 #define CONFIG_CMD_UBIFS /* Read-only UBI volume operations */
75
76 #define CONFIG_RBTREE /* required by CONFIG_CMD_UBI */
77 #define CONFIG_LZO /* required by CONFIG_CMD_UBIFS */
78
79 #define CONFIG_MTD_PARTITIONS /* required for UBI partition support */
80
81 #define MTDIDS_DEFAULT "nand0=omap2-nand.0"
82 #define MTDPARTS_DEFAULT "mtdparts=omap2-nand.0:512k(xloader),"\
83 "1920k(uboot),128k(uboot-env),"\
84 "10m(boot),-(rootfs)"
85 #else
86 #define MTDPARTS_DEFAULT
87 #endif
88
89 #define CONFIG_EXTRA_ENV_SETTINGS \
90 DEFAULT_LINUX_BOOT_ENV \
91 "usbtty=cdc_acm\0" \
92 "bootargs=ubi.mtd=4 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs " \
93 "rw rootflags=bulk_read vram=6272K omapfb.vram=0:3000K\0" \
94 "mtdparts=" MTDPARTS_DEFAULT "\0" \
95
96 #define CONFIG_BOOTCOMMAND \
97 "if mmc rescan && fatload mmc1 0 ${loadaddr} autoboot.scr || " \
98 "ext2load mmc1 0 ${loadaddr} autoboot.scr; then " \
99 "source ${loadaddr}; " \
100 "fi; " \
101 "ubi part boot && ubifsmount ubi:boot && " \
102 "ubifsload ${loadaddr} uImage && bootm ${loadaddr}"
103
104 /*
105 * Miscellaneous configurable options
106 */
107 #undef CONFIG_SYS_PROMPT
108 #define CONFIG_SYS_PROMPT "Pandora # "
109
110 /* memtest works on */
111 #define CONFIG_SYS_MEMTEST_START (OMAP34XX_SDRC_CS0)
112 #define CONFIG_SYS_MEMTEST_END (OMAP34XX_SDRC_CS0 + \
113 0x01F00000) /* 31MB */
114
115 #if defined(CONFIG_NAND)
116 #define CONFIG_SYS_FLASH_BASE NAND_BASE
117 #endif
118
119 /* Monitor at start of flash */
120 #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE
121
122 #define CONFIG_ENV_IS_IN_NAND 1
123 #define SMNAND_ENV_OFFSET 0x260000 /* environment starts here */
124
125 #define CONFIG_SYS_ENV_SECT_SIZE (128 << 10) /* 128 KiB */
126 #define CONFIG_ENV_OFFSET SMNAND_ENV_OFFSET
127 #define CONFIG_ENV_ADDR SMNAND_ENV_OFFSET
128
129 #define CONFIG_SYS_CACHELINE_SIZE 64
130
131 #endif /* __CONFIG_H */