]> git.ipfire.org Git - people/ms/u-boot.git/blob - include/configs/omap3_pandora.h
common: Add DISPLAY_BOARDINFO
[people/ms/u-boot.git] / include / configs / omap3_pandora.h
1 /*
2 * (C) Copyright 2008-2010
3 * GraÅžvydas Ignotas <notasas@gmail.com>
4 *
5 * Configuration settings for the OMAP3 Pandora.
6 *
7 * SPDX-License-Identifier: GPL-2.0+
8 */
9
10 #ifndef __CONFIG_H
11 #define __CONFIG_H
12
13 #define CONFIG_NR_DRAM_BANKS 2 /* CS1 may or may not be populated */
14 #define CONFIG_NAND
15
16 /* override base for compatibility with MLO the device ships with */
17 #define CONFIG_SYS_TEXT_BASE 0x80008000
18
19 #include <configs/ti_omap3_common.h>
20
21 #define CONFIG_MISC_INIT_R
22 #define CONFIG_REVISION_TAG 1
23
24 #define CONFIG_ENV_SIZE (128 << 10) /* 128 KiB */
25
26 #define CONFIG_SYS_CONSOLE_IS_IN_ENV 1
27 #define CONFIG_SYS_DEVICE_NULLDEV 1
28
29 /*
30 * Hardware drivers
31 */
32
33 /* I2C Support */
34 #define CONFIG_SYS_I2C_OMAP34XX
35
36 /* TWL4030 LED */
37 #define CONFIG_TWL4030_LED
38
39 /* Initialize GPIOs by default */
40 #define CONFIG_OMAP3_GPIO_4 /* GPIO96..127 is in GPIO Bank 4 */
41 #define CONFIG_OMAP3_GPIO_6 /* GPIO160..191 is in GPIO Bank 6 */
42
43 /*
44 * NS16550 Configuration
45 */
46 #undef CONFIG_SYS_NS16550_CLK
47 #define CONFIG_SYS_NS16550_SERIAL
48 #define CONFIG_SYS_NS16550_REG_SIZE (-4)
49 #define CONFIG_SYS_NS16550_CLK V_NS16550_CLK
50 #define CONFIG_SYS_NS16550_COM3 OMAP34XX_UART3
51 #define CONFIG_SERIAL3 3
52
53 /* commands to include */
54
55 /*
56 * Board NAND Info.
57 */
58 #define CONFIG_SYS_NAND_ADDR NAND_BASE /* physical address */
59 /* to access nand */
60 #define CONFIG_SYS_NAND_BUSWIDTH_16BIT
61 #define CONFIG_NAND_OMAP_ECCSCHEME OMAP_ECC_HAM1_CODE_SW
62 #define CONFIG_SYS_NAND_PAGE_SIZE 2048
63 #define CONFIG_SYS_NAND_OOBSIZE 64
64
65 #ifdef CONFIG_NAND
66 #define CONFIG_CMD_UBIFS /* Read-only UBI volume operations */
67
68 #define CONFIG_RBTREE /* required by CONFIG_CMD_UBI */
69 #define CONFIG_LZO /* required by CONFIG_CMD_UBIFS */
70
71 #define CONFIG_MTD_PARTITIONS /* required for UBI partition support */
72
73 #define MTDIDS_DEFAULT "nand0=omap2-nand.0"
74 #define MTDPARTS_DEFAULT "mtdparts=omap2-nand.0:512k(xloader),"\
75 "1920k(uboot),128k(uboot-env),"\
76 "10m(boot),-(rootfs)"
77 #else
78 #define MTDPARTS_DEFAULT
79 #endif
80
81
82 #define CONFIG_BOOTCOMMAND \
83 "run distro_bootcmd; " \
84 "setenv bootargs ${bootargs_ubi}; " \
85 "if mmc rescan && load mmc 0:1 ${loadaddr} autoboot.scr; then " \
86 "source ${loadaddr}; " \
87 "fi; " \
88 "ubi part boot && ubifsmount ubi:boot && " \
89 "ubifsload ${loadaddr} uImage && bootm ${loadaddr}"
90
91 #define BOOT_TARGET_DEVICES(func) \
92 func(MMC, mmc, 0) \
93
94 #include <config_distro_bootcmd.h>
95
96 #define CONFIG_EXTRA_ENV_SETTINGS \
97 DEFAULT_LINUX_BOOT_ENV \
98 "usbtty=cdc_acm\0" \
99 "bootargs_ubi=ubi.mtd=4 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs " \
100 "rw rootflags=bulk_read vram=6272K omapfb.vram=0:3000K\0" \
101 "mtdparts=" MTDPARTS_DEFAULT "\0" \
102 BOOTENV \
103
104 /* memtest works on */
105 #define CONFIG_SYS_MEMTEST_START (OMAP34XX_SDRC_CS0)
106 #define CONFIG_SYS_MEMTEST_END (OMAP34XX_SDRC_CS0 + \
107 0x01F00000) /* 31MB */
108
109 #if defined(CONFIG_NAND)
110 #define CONFIG_SYS_FLASH_BASE NAND_BASE
111 #endif
112
113 /* Monitor at start of flash */
114 #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_FLASH_BASE
115
116 #define CONFIG_ENV_IS_IN_NAND 1
117 #define SMNAND_ENV_OFFSET 0x260000 /* environment starts here */
118
119 #define CONFIG_SYS_ENV_SECT_SIZE (128 << 10) /* 128 KiB */
120 #define CONFIG_ENV_OFFSET SMNAND_ENV_OFFSET
121 #define CONFIG_ENV_ADDR SMNAND_ENV_OFFSET
122
123 #endif /* __CONFIG_H */