include/configs/pcm058.h

   1 /*
   2  * Copyright (C) Stefano Babic <sbabic@denx.de>
   3  *
   4  * SPDX-License-Identifier:     GPL-2.0+
   5  */
   6
   7
   8 #ifndef __PCM058_CONFIG_H
   9 #define __PCM058_CONFIG_H
  10
  11 #include <config_distro_defaults.h>
  12
  13 #ifdef CONFIG_SPL
  14 #define CONFIG_SPL_LIBCOMMON_SUPPORT
  15 #define CONFIG_SPL_YMODEM_SUPPORT
  16 #define CONFIG_SPL_MMC_SUPPORT
  17 #define CONFIG_SPL_SPI_SUPPORT
  18 #define CONFIG_SPL_SPI_FLASH_SUPPORT
  19 #define CONFIG_SPL_SPI_LOAD
  20 #define CONFIG_SYS_SPI_U_BOOT_OFFS      (64 * 1024)
  21 #include "imx6_spl.h"
  22 #endif
  23
  24 #include "mx6_common.h"
  25
  26 /* Thermal */
  27 #define CONFIG_IMX_THERMAL
  28
  29 /* Serial */
  30 #define CONFIG_MXC_UART
  31 #define CONFIG_MXC_UART_BASE           UART2_BASE
  32 #define CONFIG_CONSOLE_DEV              "ttymxc1"
  33
  34 #define PHYS_SDRAM_SIZE         (1u * 1024 * 1024 * 1024)
  35
  36 /* Early setup */
  37 #define CONFIG_BOARD_EARLY_INIT_F
  38 #define CONFIG_BOARD_LATE_INIT
  39 #define CONFIG_DISPLAY_BOARDINFO_LATE
  40
  41
  42 /* Size of malloc() pool */
  43 #define CONFIG_SYS_MALLOC_LEN           (8 * SZ_1M)
  44
  45 /* Ethernet */
  46 #define CONFIG_FEC_MXC
  47 #define CONFIG_MII
  48 #define IMX_FEC_BASE                    ENET_BASE_ADDR
  49 #define CONFIG_FEC_XCV_TYPE             RGMII
  50 #define CONFIG_ETHPRIME                 "FEC"
  51 #define CONFIG_FEC_MXC_PHYADDR          3
  52
  53 #define CONFIG_PHYLIB
  54 #define CONFIG_PHY_MICREL
  55 #define CONFIG_PHY_KSZ9031
  56
  57 /* SPI Flash */
  58 #define CONFIG_MXC_SPI
  59 #define CONFIG_SF_DEFAULT_BUS           0
  60 #define CONFIG_SF_DEFAULT_CS            0
  61 #define CONFIG_SF_DEFAULT_SPEED         20000000
  62 #define CONFIG_SF_DEFAULT_MODE          SPI_MODE_0
  63
  64 /* I2C Configs */
  65 #define CONFIG_SYS_I2C
  66 #define CONFIG_SYS_I2C_MXC
  67 #define CONFIG_SYS_I2C_MXC_I2C3         /* enable I2C bus 2 */
  68 #define CONFIG_SYS_I2C_SPEED              100000
  69
  70 #ifndef CONFIG_SPL_BUILD
  71 #define CONFIG_CMD_NAND
  72 /* Enable NAND support */
  73 #define CONFIG_CMD_NAND_TRIMFFS
  74 #define CONFIG_NAND_MXS
  75 #define CONFIG_SYS_MAX_NAND_DEVICE      1
  76 #define CONFIG_SYS_NAND_BASE            0x40000000
  77 #define CONFIG_SYS_NAND_5_ADDR_CYCLE
  78 #define CONFIG_SYS_NAND_ONFI_DETECTION
  79 #endif
  80
  81 /* DMA stuff, needed for GPMI/MXS NAND support */
  82 #define CONFIG_APBH_DMA
  83 #define CONFIG_APBH_DMA_BURST
  84 #define CONFIG_APBH_DMA_BURST8
  85
  86 /* Filesystem support */
  87 #define CONFIG_LZO
  88 #define CONFIG_CMD_UBIFS
  89 #define CONFIG_CMD_MTDPARTS
  90 #define CONFIG_MTD_PARTITIONS
  91 #define CONFIG_MTD_DEVICE
  92 #define MTDIDS_DEFAULT    "nand0=nand"
  93 #define MTDPARTS_DEFAULT  "mtdparts=nand:16m(uboot),1m(env),-(rootfs)"
  94
  95 /* Various command support */
  96 #define CONFIG_CMD_BMODE         /* set eFUSE shadow for a boot dev and reset */
  97 #define CONFIG_CMD_HDMIDETECT    /* detect HDMI output device */
  98 #define CONFIG_CMD_GSC
  99 #define CONFIG_CMD_EECONFIG      /* Gateworks EEPROM config cmd */
 100 #define CONFIG_CMD_UBI
 101 #define CONFIG_RBTREE
 102
 103 /* Physical Memory Map */
 104 #define CONFIG_NR_DRAM_BANKS           1
 105 #define PHYS_SDRAM                     MMDC0_ARB_BASE_ADDR
 106
 107 #define CONFIG_SYS_SDRAM_BASE          PHYS_SDRAM
 108 #define CONFIG_SYS_INIT_RAM_ADDR       IRAM_BASE_ADDR
 109 #define CONFIG_SYS_INIT_RAM_SIZE       IRAM_SIZE
 110
 111 #define CONFIG_SYS_INIT_SP_OFFSET \
 112         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 113 #define CONFIG_SYS_INIT_SP_ADDR \
 114         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
 115
 116 /* MMC Configs */
 117 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
 118 #define CONFIG_SYS_FSL_USDHC_NUM        1
 119
 120 /* Environment organization */
 121 #define CONFIG_ENV_IS_IN_SPI_FLASH
 122 #define CONFIG_ENV_SIZE                (16 * 1024)
 123 #define CONFIG_ENV_OFFSET               (1024 * SZ_1K)
 124 #define CONFIG_ENV_SECT_SIZE            (64 * SZ_1K)
 125 #define CONFIG_ENV_SPI_BUS             CONFIG_SF_DEFAULT_BUS
 126 #define CONFIG_ENV_SPI_CS              CONFIG_SF_DEFAULT_CS
 127 #define CONFIG_ENV_SPI_MODE            CONFIG_SF_DEFAULT_MODE
 128 #define CONFIG_ENV_SPI_MAX_HZ          CONFIG_SF_DEFAULT_SPEED
 129 #define CONFIG_SYS_REDUNDAND_ENVIRONMENT
 130 #define CONFIG_ENV_OFFSET_REDUND       (CONFIG_ENV_OFFSET + \
 131                                                 CONFIG_ENV_SECT_SIZE)
 132 #define CONFIG_ENV_SIZE_REDUND         CONFIG_ENV_SIZE
 133
 134 #ifdef CONFIG_ENV_IS_IN_NAND
 135 #define CONFIG_ENV_OFFSET              (0x1E0000)
 136 #define CONFIG_ENV_SECT_SIZE           (128 * SZ_1K)
 137 #endif
 138
 139 #endif