* If this flag is not specified, a full scan shall include all the
* supported frequencies irrespective of the ones part of an earlier
* partial scan.
+ *
+ * @QCA_ATTR_ROAM_CONTROL_FULL_SCAN_6GHZ_ONLY_ON_PRIOR_DISCOVERY: Unsigned 8-bit
+ * value.
+ * During the roam scan, if there are no desired APs found in the partial
+ * frequency list, an immediate full scan on all the supported frequencies
+ * is initiated as a fallback. This full scan would add the 2.4/5/6 GHz
+ * frequencies, including all PSC frequencies by default. This attribute
+ * controls the inclusion of the 6 GHz PSC frequencies for the full scan
+ * as following.
+ * 1 - Full scan to include the supported 6 GHz PSC frequencies only on the
+ * prior discovery of any 6 GHz frequency support in the environment.
+ * This discovery can happen through a prior RNR, 11k neighbor
+ * request, 11v BTM request, host scan, etc.
+ * 0 - Default behavior. Full scan to include all the supported 6 GHz
+ * PSC frequencies regardless of whether 6 GHz BSSs have been
+ * discovered.
+ * The default behavior if this flag is not specified is to include all
+ * the supported 6 GHz PSC frequencies in the roam full scan.
*/
enum qca_vendor_attr_roam_control {
QCA_ATTR_ROAM_CONTROL_ENABLE = 1,
QCA_ATTR_ROAM_CONTROL_LINKSPEED_THRESHOLD = 24,
QCA_ATTR_ROAM_CONTROL_HO_DELAY_FOR_RX = 25,
QCA_ATTR_ROAM_CONTROL_FULL_SCAN_NO_REUSE_PARTIAL_SCAN_FREQ = 26,
+ QCA_ATTR_ROAM_CONTROL_FULL_SCAN_6GHZ_ONLY_ON_PRIOR_DISCOVERY = 27,
/* keep last */
QCA_ATTR_ROAM_CONTROL_AFTER_LAST,