configs/ls1021aqds_sdcard_ifc_defconfig

   1 CONFIG_ARM=y
   2 CONFIG_SKIP_LOWLEVEL_INIT=y
   3 CONFIG_SPL_SKIP_LOWLEVEL_INIT=y
   4 CONFIG_COUNTER_FREQUENCY=12500000
   5 CONFIG_TARGET_LS1021AQDS=y
   6 CONFIG_TEXT_BASE=0x82000000
   7 CONFIG_SYS_MALLOC_LEN=0x1002000
   8 CONFIG_SPL_LIBCOMMON_SUPPORT=y
   9 CONFIG_SPL_LIBGENERIC_SUPPORT=y
  10 CONFIG_NR_DRAM_BANKS=1
  11 CONFIG_ENV_SIZE=0x2000
  12 CONFIG_ENV_OFFSET=0x300000
  13 CONFIG_SYS_I2C_MXC_I2C1=y
  14 CONFIG_SYS_I2C_MXC_I2C2=y
  15 CONFIG_SYS_I2C_MXC_I2C3=y
  16 CONFIG_DM_GPIO=y
  17 CONFIG_DEFAULT_DEVICE_TREE="ls1021a-qds-duart"
  18 CONFIG_SPL_TEXT_BASE=0x10000000
  19 CONFIG_SYS_MONITOR_LEN=786432
  20 CONFIG_SPL_MMC=y
  21 CONFIG_SPL_SERIAL=y
  22 CONFIG_SPL_DRIVERS_MISC=y
  23 CONFIG_SPL_STACK=0x1001d000
  24 CONFIG_SPL=y
  25 CONFIG_SYS_LOAD_ADDR=0x82000000
  26 CONFIG_PCI=y
  27 CONFIG_AHCI=y
  28 CONFIG_LAYERSCAPE_NS_ACCESS=y
  29 CONFIG_PCIE1=y
  30 CONFIG_PCIE2=y
  31 CONFIG_FSL_USE_PCA9547_MUX=y
  32 CONFIG_FSL_QIXIS=y
  33 # CONFIG_QIXIS_I2C_ACCESS is not set
  34 CONFIG_SYS_MEMTEST_START=0x80000000
  35 CONFIG_SYS_MEMTEST_END=0x9fffffff
  36 CONFIG_DYNAMIC_SYS_CLK_FREQ=y
  37 CONFIG_FIT=y
  38 CONFIG_FIT_VERBOSE=y
  39 CONFIG_SYS_BOOTM_LEN=0x4000000
  40 CONFIG_RAMBOOT_PBL=y
  41 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1021aqds/ls102xa_pbi.cfg"
  42 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1021aqds/ls102xa_rcw_sd_ifc.cfg"
  43 CONFIG_SD_BOOT=y
  44 CONFIG_BOOTDELAY=3
  45 CONFIG_SYS_CBSIZE=256
  46 CONFIG_SYS_PBSIZE=276
  47 CONFIG_SILENT_CONSOLE=y
  48 CONFIG_SYS_CONSOLE_IS_IN_ENV=y
  49 CONFIG_ARCH_MISC_INIT=y
  50 CONFIG_MISC_INIT_R=y
  51 CONFIG_ID_EEPROM=y
  52 CONFIG_SPL_MAX_SIZE=0x1a000
  53 CONFIG_SPL_PAD_TO=0x1c000
  54 CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
  55 CONFIG_SPL_BSS_START_ADDR=0x80100000
  56 CONFIG_SPL_BSS_MAX_SIZE=0x80000
  57 CONFIG_SPL_FSL_PBL=y
  58 # CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
  59 CONFIG_SPL_SYS_MALLOC=y
  60 CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y
  61 CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x820c0000
  62 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
  63 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8
  64 CONFIG_SPL_ENV_SUPPORT=y
  65 CONFIG_SPL_I2C=y
  66 CONFIG_SPL_MPC8XXX_INIT_DDR=y
  67 CONFIG_SPL_WATCHDOG=y
  68 CONFIG_HUSH_PARSER=y
  69 CONFIG_CMD_BOOTZ=y
  70 CONFIG_CMD_IMLS=y
  71 CONFIG_CMD_GREPENV=y
  72 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
  73 CONFIG_CMD_MEMINFO=y
  74 CONFIG_CMD_MEMTEST=y
  75 CONFIG_CMD_GPIO=y
  76 CONFIG_CMD_GPT=y
  77 CONFIG_CMD_I2C=y
  78 CONFIG_CMD_MMC=y
  79 CONFIG_CMD_NAND=y
  80 CONFIG_CMD_USB=y
  81 # CONFIG_CMD_SETEXPR is not set
  82 CONFIG_CMD_DHCP=y
  83 CONFIG_CMD_MII=y
  84 CONFIG_CMD_PING=y
  85 CONFIG_CMD_EXT2=y
  86 CONFIG_CMD_FAT=y
  87 # CONFIG_SPL_EFI_PARTITION is not set
  88 CONFIG_OF_CONTROL=y
  89 CONFIG_ENV_OVERWRITE=y
  90 CONFIG_ENV_IS_IN_MMC=y
  91 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
  92 CONFIG_USE_ETHPRIME=y
  93 CONFIG_ETHPRIME="eTSEC1"
  94 CONFIG_SATA=y
  95 CONFIG_SATA_CEVA=y
  96 CONFIG_FSL_CAAM=y
  97 CONFIG_DYNAMIC_DDR_CLK_FREQ=y
  98 CONFIG_SYS_FSL_DDR3=y
  99 CONFIG_DDR_ECC=y
 100 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
 101 CONFIG_SYS_DDR_RAW_TIMING=y
 102 CONFIG_MPC8XXX_GPIO=y
 103 CONFIG_DM_I2C=y
 104 CONFIG_SPL_SYS_I2C_LEGACY=y
 105 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
 106 CONFIG_SYS_I2C_EEPROM_ADDR=0x57
 107 CONFIG_FSL_ESDHC=y
 108 CONFIG_MTD=y
 109 CONFIG_MTD_NOR_FLASH=y
 110 CONFIG_FLASH_CFI_DRIVER=y
 111 CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y
 112 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
 113 CONFIG_SYS_FLASH_EMPTY_INFO=y
 114 CONFIG_SYS_FLASH_CFI=y
 115 CONFIG_SYS_FLASH_QUIET_TEST=y
 116 CONFIG_SYS_MAX_FLASH_SECT=1024
 117 CONFIG_SYS_MAX_FLASH_BANKS=2
 118 CONFIG_MTD_RAW_NAND=y
 119 CONFIG_NAND_FSL_IFC=y
 120 CONFIG_SYS_NAND_ONFI_DETECTION=y
 121 CONFIG_PHY_REALTEK=y
 122 CONFIG_PHY_GIGE=y
 123 CONFIG_E1000=y
 124 CONFIG_MII=y
 125 CONFIG_TSEC_ENET=y
 126 CONFIG_NVME_PCI=y
 127 CONFIG_DM_PCI_COMPAT=y
 128 CONFIG_PCIE_LAYERSCAPE_RC=y
 129 CONFIG_SYS_NS16550_SERIAL=y
 130 CONFIG_USB=y
 131 CONFIG_USB_XHCI_HCD=y
 132 CONFIG_USB_XHCI_DWC3=y
 133 CONFIG_USB_STORAGE=y