+This value can be set with
+.B --grow
+for RAID level 1/4/5/6. If the array was created with a size smaller
+than the currently active drives, the extra space can be accessed
+using
+.BR --grow .
+The size can be given as
+.B max
+which means to choose the largest size that fits on all current drives.
+
+.TP
+.BR --assume-clean
+Tell
+.I mdadm
+that the array pre-existed and is known to be clean. It can be useful
+when trying to recover from a major failure as you can be sure that no
+data will be affected unless you actually write to the array. It can
+also be used when creating a RAID1 or RAID10 if you want to avoid the
+initial resync, however this practice - while normally safe - is not
+recommended. Use this ony if you really know what you are doing.
+
+.TP
+.BR -N ", " --name=
+Set a
+.B name
+for the array. This is currently only effective when creating an
+array with a version-1 superblock. The name is a simple textual
+string that can be used to identify array components when assembling.
+
+.TP
+.BR -R ", " --run
+Insist that
+.I mdadm
+run the array, even if some of the components
+appear to be active in another array or filesystem. Normally
+.I mdadm
+will ask for confirmation before including such components in an
+array. This option causes that question to be suppressed.
+
+.TP
+.BR -f ", " --force
+Insist that
+.I mdadm
+accept the geometry and layout specified without question. Normally
+.I mdadm
+will not allow creation of an array with only one device, and will try
+to create a raid5 array with one missing drive (as this makes the
+initial resync work faster). With
+.BR --force ,
+.I mdadm
+will not try to be so clever.
+
+.TP
+.BR -a ", " "--auto{=no,yes,md,mdp,part,p}{NN}"
+Instruct mdadm to create the device file if needed, possibly allocating
+an unused minor number. "md" causes a non-partitionable array
+to be used. "mdp", "part" or "p" causes a partitionable array (2.6 and
+later) to be used. "yes" requires the named md device to haveo
+a 'standard' format, and the type and minor number will be determined
+from this. See DEVICE NAMES below.
+
+The argument can also come immediately after
+"-a". e.g. "-ap".
+
+If
+.I --scan
+is also given, then any
+.I auto=
+entries in the config file will over-ride the
+.I --auto
+instruction given on the command line.
+
+For partitionable arrays,
+.I mdadm
+will create the device file for the whole array and for the first 4
+partitions. A different number of partitions can be specified at the
+end of this option (e.g.
+.BR --auto=p7 ).
+If the device name ends with a digit, the partition names add a'p',
+and a number, e.g. "/dev/home1p3". If there is no
+trailing digit, then the partition names just have a number added,
+e.g. "/dev/scratch3".
+
+If the md device name is in a 'standard' format as described in DEVICE
+NAMES, then it will be created, if necessary, with the appropriate
+number based on that name. If the device name is not in one of these
+formats, then a unused minor number will be allocated. The minor
+number will be considered unused if there is no active array for that
+number, and there is no entry in /dev for that number and with a
+non-standard name.
+