include/configs/mx53loco.h

   1 /*
   2  * Copyright (C) 2011 Freescale Semiconductor, Inc.
   3  * Jason Liu <r64343@freescale.com>
   4  *
   5  * Configuration settings for Freescale MX53 low cost board.
   6  *
   7  * SPDX-License-Identifier:     GPL-2.0+
   8  */
   9
  10 #ifndef __CONFIG_H
  11 #define __CONFIG_H
  12
  13 #define CONFIG_MX53
  14
  15 #define CONFIG_DISPLAY_BOARDINFO
  16
  17 #define CONFIG_MACH_TYPE        MACH_TYPE_MX53_LOCO
  18
  19 #include <asm/arch/imx-regs.h>
  20
  21 #define CONFIG_CMDLINE_TAG
  22 #define CONFIG_SETUP_MEMORY_TAGS
  23 #define CONFIG_INITRD_TAG
  24
  25 #define CONFIG_SYS_FSL_CLK
  26
  27 /* Size of malloc() pool */
  28 #define CONFIG_SYS_MALLOC_LEN           (10 * 1024 * 1024)
  29
  30 #define CONFIG_BOARD_EARLY_INIT_F
  31 #define CONFIG_BOARD_LATE_INIT
  32 #define CONFIG_MXC_GPIO
  33 #define CONFIG_REVISION_TAG
  34
  35 #define CONFIG_MXC_UART
  36 #define CONFIG_MXC_UART_BASE    UART1_BASE
  37
  38 /* MMC Configs */
  39 #define CONFIG_FSL_ESDHC
  40 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
  41 #define CONFIG_SYS_FSL_ESDHC_NUM        2
  42
  43 #define CONFIG_MMC
  44 #define CONFIG_CMD_MMC
  45 #define CONFIG_GENERIC_MMC
  46 #define CONFIG_CMD_FS_GENERIC
  47 #define CONFIG_CMD_FAT
  48 #define CONFIG_CMD_EXT2
  49 #define CONFIG_DOS_PARTITION
  50
  51 /* Eth Configs */
  52 #define CONFIG_MII
  53
  54 #define CONFIG_FEC_MXC
  55 #define IMX_FEC_BASE    FEC_BASE_ADDR
  56 #define CONFIG_FEC_MXC_PHYADDR  0x1F
  57
  58 #define CONFIG_CMD_PING
  59 #define CONFIG_CMD_DHCP
  60 #define CONFIG_CMD_MII
  61
  62 /* USB Configs */
  63 #define CONFIG_CMD_USB
  64 #define CONFIG_CMD_FAT
  65 #define CONFIG_USB_EHCI
  66 #define CONFIG_USB_EHCI_MX5
  67 #define CONFIG_USB_STORAGE
  68 #define CONFIG_USB_HOST_ETHER
  69 #define CONFIG_USB_ETHER_ASIX
  70 #define CONFIG_USB_ETHER_MCS7830
  71 #define CONFIG_USB_ETHER_SMSC95XX
  72 #define CONFIG_MXC_USB_PORT     1
  73 #define CONFIG_MXC_USB_PORTSC   (PORT_PTS_UTMI | PORT_PTS_PTW)
  74 #define CONFIG_MXC_USB_FLAGS    0
  75
  76 /* I2C Configs */
  77 #define CONFIG_SYS_I2C
  78 #define CONFIG_SYS_I2C_MXC
  79 #define CONFIG_SYS_I2C_MXC_I2C1         /* enable I2C bus 1 */
  80 #define CONFIG_SYS_I2C_MXC_I2C2         /* enable I2C bus 2 */
  81 #define CONFIG_SYS_I2C_MXC_I2C3         /* enable I2C bus 3 */
  82
  83 /* PMIC Controller */
  84 #define CONFIG_POWER
  85 #define CONFIG_POWER_I2C
  86 #define CONFIG_DIALOG_POWER
  87 #define CONFIG_POWER_FSL
  88 #define CONFIG_POWER_FSL_MC13892
  89 #define CONFIG_SYS_DIALOG_PMIC_I2C_ADDR 0x48
  90 #define CONFIG_SYS_FSL_PMIC_I2C_ADDR    0x8
  91
  92 /* allow to overwrite serial and ethaddr */
  93 #define CONFIG_ENV_OVERWRITE
  94 #define CONFIG_CONS_INDEX               1
  95 #define CONFIG_BAUDRATE                 115200
  96
  97 /* Command definition */
  98 #define CONFIG_CMD_BOOTZ
  99 #define CONFIG_SUPPORT_RAW_INITRD
 100
 101 #define CONFIG_BOOTDELAY        1
 102
 103 #define CONFIG_ETHPRIME         "FEC0"
 104
 105 #define CONFIG_LOADADDR         0x72000000      /* loadaddr env var */
 106 #define CONFIG_SYS_TEXT_BASE    0x77800000
 107
 108 #define CONFIG_EXTRA_ENV_SETTINGS \
 109         "script=boot.scr\0" \
 110         "image=zImage\0" \
 111         "fdt_addr=0x71000000\0" \
 112         "boot_fdt=try\0" \
 113         "ip_dyn=yes\0" \
 114         "mmcdev=0\0" \
 115         "mmcpart=1\0" \
 116         "mmcroot=/dev/mmcblk0p2 rw rootwait\0" \
 117         "mmcargs=setenv bootargs console=ttymxc0,${baudrate} root=${mmcroot}\0" \
 118         "loadbootscript=" \
 119                 "load mmc ${mmcdev}:${mmcpart} ${loadaddr} ${script};\0" \
 120         "bootscript=echo Running bootscript from mmc ...; " \
 121                 "source\0" \
 122         "loadimage=load mmc ${mmcdev}:${mmcpart} ${loadaddr} ${image}\0" \
 123         "loadfdt=load mmc ${mmcdev}:${mmcpart} ${fdt_addr} ${fdt_file}\0" \
 124         "mmcboot=echo Booting from mmc ...; " \
 125                 "run mmcargs; " \
 126                 "if test ${boot_fdt} = yes || test ${boot_fdt} = try; then " \
 127                         "if run loadfdt; then " \
 128                                 "bootz ${loadaddr} - ${fdt_addr}; " \
 129                         "else " \
 130                                 "if test ${boot_fdt} = try; then " \
 131                                         "bootz; " \
 132                                 "else " \
 133                                         "echo WARN: Cannot load the DT; " \
 134                                 "fi; " \
 135                         "fi; " \
 136                 "else " \
 137                         "bootz; " \
 138                 "fi;\0" \
 139         "netargs=setenv bootargs console=ttymxc0,${baudrate} " \
 140                 "root=/dev/nfs " \
 141                 "ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp\0" \
 142         "netboot=echo Booting from net ...; " \
 143                 "run netargs; " \
 144                 "if test ${ip_dyn} = yes; then " \
 145                         "setenv get_cmd dhcp; " \
 146                 "else " \
 147                         "setenv get_cmd tftp; " \
 148                 "fi; " \
 149                 "${get_cmd} ${image}; " \
 150                 "if test ${boot_fdt} = yes ||  test ${boot_fdt} = try; then " \
 151                         "if ${get_cmd} ${fdt_addr} ${fdt_file}; then " \
 152                                 "bootz ${loadaddr} - ${fdt_addr}; " \
 153                         "else " \
 154                                 "if test ${boot_fdt} = try; then " \
 155                                         "bootz; " \
 156                                 "else " \
 157                                         "echo ERROR: Cannot load the DT; " \
 158                                         "exit; " \
 159                                 "fi; " \
 160                         "fi; " \
 161                 "else " \
 162                         "bootz; " \
 163                 "fi;\0"
 164
 165 #define CONFIG_BOOTCOMMAND \
 166         "mmc dev ${mmcdev}; if mmc rescan; then " \
 167                 "if run loadbootscript; then " \
 168                         "run bootscript; " \
 169                 "else " \
 170                         "if run loadimage; then " \
 171                                 "run mmcboot; " \
 172                         "else run netboot; " \
 173                         "fi; " \
 174                 "fi; " \
 175         "else run netboot; fi"
 176
 177 #define CONFIG_ARP_TIMEOUT      200UL
 178
 179 /* Miscellaneous configurable options */
 180 #define CONFIG_SYS_LONGHELP             /* undef to save memory */
 181 #define CONFIG_AUTO_COMPLETE
 182 #define CONFIG_SYS_CBSIZE               512     /* Console I/O Buffer Size */
 183
 184 #define CONFIG_SYS_MAXARGS      16      /* max number of command args */
 185 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
 186
 187 #define CONFIG_SYS_MEMTEST_START       0x70000000
 188 #define CONFIG_SYS_MEMTEST_END         0x70010000
 189
 190 #define CONFIG_SYS_LOAD_ADDR            CONFIG_LOADADDR
 191
 192 #define CONFIG_CMDLINE_EDITING
 193
 194 /* Physical Memory Map */
 195 #define CONFIG_NR_DRAM_BANKS    2
 196 #define PHYS_SDRAM_1                    CSD0_BASE_ADDR
 197 #define PHYS_SDRAM_1_SIZE               (gd->bd->bi_dram[0].size)
 198 #define PHYS_SDRAM_2                    CSD1_BASE_ADDR
 199 #define PHYS_SDRAM_2_SIZE               (gd->bd->bi_dram[1].size)
 200 #define PHYS_SDRAM_SIZE                 (gd->ram_size)
 201
 202 #define CONFIG_SYS_SDRAM_BASE           (PHYS_SDRAM_1)
 203 #define CONFIG_SYS_INIT_RAM_ADDR        (IRAM_BASE_ADDR)
 204 #define CONFIG_SYS_INIT_RAM_SIZE        (IRAM_SIZE)
 205
 206 #define CONFIG_SYS_INIT_SP_OFFSET \
 207         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 208 #define CONFIG_SYS_INIT_SP_ADDR \
 209         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
 210
 211 /* FLASH and environment organization */
 212 #define CONFIG_SYS_NO_FLASH
 213
 214 #define CONFIG_ENV_OFFSET      (6 * 64 * 1024)
 215 #define CONFIG_ENV_SIZE        (8 * 1024)
 216 #define CONFIG_ENV_IS_IN_MMC
 217 #define CONFIG_SYS_MMC_ENV_DEV 0
 218
 219 #define CONFIG_CMD_SATA
 220 #ifdef CONFIG_CMD_SATA
 221         #define CONFIG_DWC_AHSATA
 222         #define CONFIG_SYS_SATA_MAX_DEVICE      1
 223         #define CONFIG_DWC_AHSATA_PORT_ID       0
 224         #define CONFIG_DWC_AHSATA_BASE_ADDR     SATA_BASE_ADDR
 225         #define CONFIG_LBA48
 226         #define CONFIG_LIBATA
 227 #endif
 228
 229 /* Framebuffer and LCD */
 230 #define CONFIG_PREBOOT
 231 #define CONFIG_VIDEO
 232 #define CONFIG_VIDEO_IPUV3
 233 #define CONFIG_CFB_CONSOLE
 234 #define CONFIG_VGA_AS_SINGLE_DEVICE
 235 #define CONFIG_SYS_CONSOLE_IS_IN_ENV
 236 #define CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE
 237 #define CONFIG_VIDEO_BMP_RLE8
 238 #define CONFIG_SPLASH_SCREEN
 239 #define CONFIG_BMP_16BPP
 240 #define CONFIG_VIDEO_LOGO
 241 #define CONFIG_IPUV3_CLK        200000000
 242
 243 #endif                          /* __CONFIG_H */